Red NGK racing plug boot and wire combo. Super insulated silicone for ultimate waterproofing. 7mm solid copper wire inner core with integrated 5K Ohm ceramic resistor spark plug wire. This is about the best spark plug boot money can buy. Comes with about 20" of wire.

Change your plug on the go with this 3/16" spark plug tool.

index washers for 14mm spark plugs! comes with a variety of sizes for your tuning pleasures.

comes with two of each color!

red - 1.4mm thick
blue - 1.1mm thick
silver - 0.9mm thick
yellow - 0.7mm thick

Blue rubber waterproof spark plug boot for 7mm spark plug wire.

ADD TO CART TO CHECK STOCK!
NGK spark plugs. BHS series. Best in the world!

NGK spark plugs. Long thread BES series.

ADD TO CART TO CHECK STOCK!

NGK spark plugs. Resistor type short thread plugs.

NGK spark plugs. Resistor type long thread plugs.

NGK spark plug boot LB05FP. This is the resistor type that uses the little cap on the tip of the plug. 90 degree bend for those hard to reach places!

Red rubber waterproof spark plug boot for 7mm spark plug wire. This is a resistor type boot that uses the screw-on cap on top of the plug.

No display, just about 22" of lead wire and the copper sensor for 14mm spark plugs.

3M brand 3/16" or 5mm ID heat shrink tubing sold by the foot. Perfect for these spade terminal quick connects

Black rubber waterproof spark plug boot for 7mm spark plug wire. This is a resistor type boot that uses the screw-on cap on top of the plug.

NGK resistor spark plug boot plus 2 bonus feet of 7mm spark plug wire - now in a convenient combo party pack!

High speed racing competition 7mm spark plug wire and boot made out of waterproof silicone. This is a must have for any race engine. Similar specs to the Atomic / NGK racing spark plug wire/boot setups, but a bit cheaper as this is the off brand! Save your pennies to spend on a kit or pipe or something, yep.

Replacement HPI external ignition CDI coil for all the HPI CDI units. You can also use this on any other 6v or 12v cdi unit or points ignition as well. Comes with about a foot and a half of ignition wire.

Stock metal plug boot for any moped. Traditionalists rejoice!

This is a 400ml spray bottle of electrical component and contact cleaner from Belray. An essential for any hobbyist or professional moped mechanic.

Replacement HPI mini rotor flywheel for Puch, sachs, derbi and tomos HPI mini rotor ignitions.

7mm spark plug wire for any moped.

Replacement nuts for original Motobecane spark plug wire. Your moby uses two of these for one spark plug wire.

Original stock wiring harness for Carabela mopeds. You could probably make this work on almost any moped, and would be super easy to adapt to v1 powered bikes.

Green rubber waterproof spark plug boot for 7mm spark plug wire. This is a resistor type boot that uses the screw-on cap on top of the plug.