Cable stop for magura controls. Sold individually.

mini cable knarp for moped cables. most people use these on their clutch or throttle ends.

measures M4 - 7mm long - 5mm OD

puch magnum style moped pedals!! these are 9/16" thread and will fit most mopeds!

long cable knarp for moped cables. works great for brakes

M6 - 15mm long - 8mm OD - 7mm

5mm cable housing end cap for capping the end of your cable housing. You need two of these per cable.

Find other custom cable makings here.

6mm pinch bolt for certain brake plate styles. You'll know if you need this.

Original OEM Puch internal tensioner for za50 motors. I'm sure you're all familiar with this thing. This moment of frustration brought to you by: Puch.

Stainless steel braided 34" hydraulic brake line for your custom moped project!

Puch ZA50 clutch cable adjuster cover. These are 3D printed in black plastic by KONDO.

malossi throttle 90 degree cable bendy adjuster

angle your throttle cable where you wish

for bing carburetors 12mm through 17mm and all dellorto carburetors, SHA, PHBG, PHVA and mikuni and more.

26 3997

cable end is M6 x 0.75mm threading

Throttle slider for Domino throttles. This is NOT the type used on most 70s era mopeds.

You can find that one in treatland here.

Plastic nut for tensioning motobecane brake cables.

1.5mm ID and 5mm OD throttle cable housing for making custom cables. Sold by the foot! So measure your cables before buying!

Find the inner cable here.
Find more custom cable stuff here.

2mm ID and 6mm OD cable housing for making custom cables. Sold by the foot! So measure your cables before buying!

Find the inner cable here.
Find more custom cable stuff here.

6mm cable housing end cap for capping the end of your cable housing. Kinda like a palindrome mayybeee? You need two of these per cable.

Find other custom cable makings here.

1.5mm inner cable housing for making custom cables. This size is best used for throttle cables, choke cables and maaaaaybe even decomp cables.

Sold by the foot.

Find the outer housing for it here.
Find other custom cable makings here.

2mm inner cable housing for making custom cables. This size is best used for front and rear brake cables and maaaaaybe even decomp cables.

Sold by the foot.

Find the outer housing for it here.
Find other custom cable makings here.

M6 thread slotted cable adjuster. Some controls require this kind of adjuster, you'll know if you need it! Threaded part of the bolt is 19mm long.

Derbi control cable holder. For stopping those rowdy cables.

m6 nut for threaded brake cable ends. Usually found on General, Lazer, Sachs, Trac etc.

This is the little bit of cable that goes in between the de-comp and the case on sachs engines.

M6 thread slotted cable adjuster. Some controls require this kind of adjuster, you'll know if you need it! Threaded part of the bolt is 25mm long.