Universal rear axle adjusters for any moped that uses this type of adjusters.

Larger of the two bearings in a puch za50 clutch cover.

OEM Tomos 12mm sealed rear axle.

Universal 12mm sealed axle bearing for front wheels. 165m with spacers.

Universal 12mm sealed axle bearing for rear wheels. 190mm long with spacers.

Spacer for derbi rear wheels.

12mm ID
19.5mm long

Sealed bearing axle for Puch mopeds or any other 12mm sealed bearing application.

New old stock Jawa 210 rear wheel spacer.

12mm ID
17mm OD
10mm wide

OEM part number: 28.4041

Italian style axle adjusters. These came on almost every bike manufactured in italy - Minarelli, Morini, Tomos, Carabela, Sachs, Garelli etc.

There are left and right side adjusters. Make sure you get the ones you need! (one of each)

Will accept 10mm - 12mm axles.

16101 bearing used for one of the two bearings you'll need in a puch za50 clutch cover and also for lots of spoke and mag wheel bearings.

You'll need two of these if you're gonna rebuild your 12mm loose bearing axle.

11mm axle nut with 19mm OD hex.

12mm x 175mm loose bearing axle for many mopeds. At this length you probably want to use it in the rear, but measure first! Comes with axle and cone nuts.

You'll need two of these if you're gonna rebuild your 11mm loose bearing axle.

Bearing for converting Puch spoke wheels over to sealed bearings. You'll also need some shim stock to make em fit nice and snug.

Comes with a plastic or metal seal.

High quality SKF, NTN, FAG, NKE, NACHI, ZKL or similar bearing. No junk.

Larger of the two bearings in a puch za50 clutch cover.

6201 wheel bearing for most italian mags and some spokes. 32mm OD, 12mm ID.