Universal voltage regulator for 6v or 12v systems. Has four prongs on a metal frame. This is pretty much the same as a the regulators that came stock on A35 bullet, targa, sprint, colibri, tt, classic, targa LX and A55 arrow (05 only!), LX, ST, and sprint.

Replacement Puch and Batavus points with condenser wire.

Super heavy duty universal ignition condenser for wiring externally. Get some new connectors if you need them.

Original Tomos A55 70A 12V DC four pronged relay. Found on Streetmates, Arrows, and Revivals.

Fitment:
-2004 - 2012 Tomos Revival
-2006 - 2008 Tomos Arrow R
-2005 - 2012 Tomos Streetmate and Streetmate R

12 volt, 70 amp 30, 85, 86, 87. OEM Tomos part number: 230843.

Extra slim low profile digital voltmeter by Koso for checking the voltage coming out of your 12v CDI or battery. Compact, easy-to-read LCD display Displays voltage within 8-18V range. When the voltage is lower than 11.5V, the meter will flash to warn you.

Trail Tech A/C Voltage Regulator. Stop blowing out those lights on kitted bikes! -Improved A/C Regulator with Adjustable Output.

HPI regulator rectifier for keeping your lights from blowing out and for running and charging a battery.

OEM BOSCH brand replacement points for Puch, Batavus, and Sachs mopeds.

Replacement points for your kreidler.

150 watt full wave regulator/rectifier for DC electrical systems. Built in relay activates switched 12V DC output line only when engine is running, with adjustable shut-off delay.

Replacement HPI external ignition CDI coil for all the HPI CDI units. You can also use this on any other 6v or 12v cdi unit or points ignition as well. Comes with about a foot and a half of ignition wire.

Replacement HPI mini rotor flywheel for Puch, sachs, derbi and tomos HPI mini rotor ignitions.

New old stock original ignition condenser made by Ducati for minarelli p4 ignitions.

OEM part number: 2300-1166

You can refer to this minarelli p4 shop manual for oem part numbers and diagrams.

CEV yellow wire points for italian stators. Probably for garelli, minarelli or morini.

Check the specs and match yours up with the picture before you buy these!

Locating pin dimensions: 4mm wide, 3.5mm tall

CEV with wire points for italian stators. Probably for garelli, minarelli or morini. wire may not be yellow on this one.

Check the specs and match yours up with the picture before you buy these!

Locating pin dimensions: 4mm wide, 3.5mm tall

replacement CEV wire points for italian stators. Probably for garelli, minarelli, carabela or morini.

Check the specs and match yours up with the picture before you buy these!

Locating pin dimensions: 3.9mm wide, 2.8mm tall

CEV yellow wire points for italian stators. Probably for garelli, minarelli, carabela or morini.

Check the specs and match yours up with the picture before you buy these!

Locating pin dimensions: 4mm wide, 6mm tall

NOS CEV points with wire for Carabela moped points ignitions like the ones found here.

Weird regulator/rectifier originally for the Carabela motos but i'm sure it'll work on whatever ya want. I've also seen these on some lazers and generals.

Replacement Motobecane points for most Mobylette mopeds with av88, av7 or av10 engines.

new old stock replacement points for motoplat ignitions found on piston port and pyramid reed engines!!

double check the photo and compare with your existing points to be sure yer gettin the right thing!!

made in spain by motosplat

Universal lighting regulator for all 6v or 12v mopeds. Run the lighting lead from your stator into the yellow wire and run the red wire out to all the lights you need regulated. This grounds through the mounting hole.

Internal condenser for puch, batavus, sachs, kriedler, solo - most Bosch ignitions. This is the screw top type.

Internal condenser for puch, batavus, sachs, kriedler, solo - most Bosh ignitions. You gotta unsolder your old one and solder this one back in.

Contact breaker points for Peugeot 103 and 104 engines.